Φ52 load electric materials are galvanized, stainless steel 201 and 304 stainless steel are three users need to consider when doing thoughtful engineering solutions. Principle: The design of the electric field so that the soot particle velocity is low, usually within a few tenths will make enough charge on soot particle charge, charged particles in an electric field will be the electric force (Coulomb force) action, the result is soot particles are adsorbed onto the anode and therefore power except fume fume removal rate is very high, and is particularly suitable for capturing smaller particle size and lighter weight of soot particles. Maintenance: 1, cleaning electric field components: 1:25 solution of caustic soda and hot water mixed with a weight ratio of foam wash. When the bubble wash solution required under the heating, or heating solution with high temperature steam. If the heat is generated when the oil, caustic soda and hot water needs to be appropriate to increase the weight. (Note that the ratio of the weight ratio of the content of 98% caustic soda solid NaOH) 2, cleaning porcelain: cleaning up the oil with detergent or lye four support cathode holder porcelain vases and high output on the rear, you must then water Rinse the detergent or lye attached to the surface, as shown in the last four with a dry cloth. 3 detects the electric field: ① Maintenance: Check whether an external anode cylinder dented site. If so, then stick with the round will slowly recover. ② Calibration Procedure: Before installing the electric field back, you must carefully check the deviation of the anode and cathode, the electric field component gently on a flat place, with vendors cathode bias detector positions each of the cathode pin, If a small hole in the middle part of the cathode can see the needle, indicating that the position of the needle within the allowable deviation range, otherwise required correction rod correction cathode needle into the allowable range.